Brian Miller's Surgical Designs

  • Home
  • The Little Red Book
  • Bullmastiffs
  • Visceral RetainerClick to open the Visceral Retainer menu
    • Video of Visceral Retainer
  • About Us
  • Contact Us

MILLER'S VISCERAL RETAINER

Miller's Visceral Retainer                 

 

  • Silastic 
  • Flexible
  • Radiopaque
  • Resterilisable
  • Latex free

             The 2009 version of the well known MVR.

MVR sweetlip, designed by Howie Engineering, Brisbane, May 09


INDICATIONS FOR USE:

Usual indications for employing a visceral retainer during the closure of
the anterior abdominal wall after an operation where the peritoneal cavity
has been entered are as follows:
    1. Bowel obstruction, where the   
        intestines are distended with
        retained gas, fluid or faeces.

    2. At the conclusion of an anaesthetic  
        where nitrous oxide had been used as one of the anaesthetic
        agents, causing distension of the bowel.    


   3. At the conclusion of an anaesthetic where neuromuscular
       blockade is beginning to wear off, causing an increase in tone
       in the abdominal wall musculature and the tendency for the
       bowels to protrude.

4. Marked intra-abdominal obesity

     

Regular use of Miller's Visceral Retainer can be expected to
reduce inadvertent visceral injury during abdominal closure,
and also needle stick injury to staff in theatre.

The frequency where a visceral retainer would be helpful is at least
fortnightly for an averagely busy general surgeon.  Maximum benefit
will be obtained if Miller's Visceral Retainer is on the list of standard
instruments put out for laparotomy.

Always remove the Retainer by gently pulling it out by the handle in a
caudal direction in order to leave the omentum in the correct position.

                           Dr Brian Miller with MVR 'sweetlip' June 2010

  • INSTRUCTIONS FOR RE-PROCESSING MILLER'S VISCERAL RETAINER

    NB Sterilize wrapped in non-papery material for at least the first sterilization to avoid lint adhering to the silastic.

    CLEANING

    • Manually clean by scrubbing with a clean sponge or soft brush in a warm water and enzymatic solution,
      or hot water and neutral detergent solution.
    • Then clean mechanically by standard process, omiting ultrasonic exposure.
    • Rinse thoroughly.
    • Dry.

    PACKAGING

    • Package in non-linting material; either wrap or peel pouch, according to proposed method of sterilization.

    STERILIZATION

    • Steam under pressure

    Minimum holding time in minutes plus safety factor

    121 degrees C    103kPa     15psi     15 mins
    126 degrees C    138kPa     20psi     10 mins
    132 degrees C    186kPa     27psi      4 mins  
    134 degrees C    206kPa     30psi      3 mins  

    • Radiation

    Exposure at 2.5 megarads produces minimal physical property changes even at 200% elongation.

    • Sterrad

    Compatible with Sterrad

    Ethylene Oxide

    This method is NOT Recommended because of the risk of residual ETO.

     

    TO ORDER:
    Phone:  07 3399 1137    Fax: 07 3240 5390

    E mail:  
    bandr@uq.edu.au

    OR ORDER FROM OUR DISTRIBUTORS:  

    Elite Medical

    128 Lytton Rd (P.O. Box 322)

    Bulimba QLD 4171

    Phone: 07 38991300

    Fax: 07 33995858

    Toll free: 1800354836


     


 

 

 

Copyright 2011 No business name. All rights reserved.

Web Hosting by Yahoo!